Radial Engineering EXTC-SA

Radial Engineering EXTC-SA Effects Reamper

The Radial EXTC SA Effects Reamper is a stand-alone audio interface that lets you incorporate guitar effects into the realm of pro-audio recording. Just imagine add a touch of grit to a vocal track, some wah on a kick drum, maybe flange a violinThe EXTC SA is a creative tool made for your esoteric-inventive side, ready to unleash fresh new sounds that will make your recordings stand out from the crowd.

And it's super easy to use: connect a line level signal from the recording system. The Radial EXTC-SA unbalances the signal and converts it to high impedance where guitar pedals can be inserted at will. Simply plug in, turn the track on, set your levels and adjust the blend for just the right amount of magic. Be prepared for instant amazement. 

Main features:

• Balanced interface for guitar effects pedals
• Separate send & receive controls optimize signal path
• Transformer isolation helps eliminate ground loops
• Creative tool helps your mix stand out from the rest

Recommended applications:

• Reamping through Pedals - Take a dry track, send it to the Radial EXTC SA which in turn feeds your pedals. This is the perfect way to add some extra zest to a vocal track; an envelope follower to a kick; or some wah to that Hammond.
• Reamping with the EXTC - The Radial EXTC SA is well suited for Reamping. Simply connect the pre-recorded channel to the Radial EXTC SA and then split the signal off to two amps using the send connectors. You are set to go!

Technical Specifications:

• Circuit Type: Solid state with transformer coupled effects loop
• Power Requirement: 60mA, ±16VDC
• Output Gain:
  • 12dB - send & receive at maximum
  • 6dB - send minimum/receive maximum
  • 0dB - send & receive set at 12 oclock
• Frequency Response: (Dry) 20Hz ~ 20kHz ±1.5dB, (Wet) 20Hz ~ 10kHz ±3.5dB (-8dB @ 20kHz)
• THD+N: (Dry) >0.005% 0dB output, (Wet) >0.002% 0dB output
• Noise: (Dry) -93dB, (Wet) -84dB
• Intermodulation Distortion: (Dry) >0.003% 0dBu input, (Wet) <0.02% 0dBu input
• Maximum Input: (Dry) +26dBu, (Wet) +20dBu
• Effects Loop I/O:
  • Connector: (Send 1/4" Output) Unbalanced ¼", (Receive 1/4" Input) Unbalanced ¼"
  • Impedance: Send 1/4" Output: 1.5k Ohms, Receive 1/4" Input: 10K Ohms
  • Gain (Variable): (Send 1/4" Output) From -14dB ~ +3dB 0dB at center point, (Receive 1/4" Input) From -99dB ~ +9dB 0dB at center point
  • Maximum Gain: (Send) 1/4" Output: ±3dB, (Receive) 1/4" Input: +9dB
• Line Level I/O:
  • Connector: (Input) Balanced XLR Female, Rear Panel, (Output) Balanced XLR Male, Rear Panel
  • Impedance: (Input) 15k Ohms, (Output) 200 Ohms
  • Headroom: (Output) +25dBu
• Conditions: For indoor use at temperatures between +5° c and +40° c